Silvercrest 349710 2007 - Mounting Blender Jug and Lid; Adding Ingredients to Blender

41
GB
Mounting the blender jug
1. Reach into the recessed grip and re-
move the cover8 upwards.
2. Position the blender jug5 on the drive
unit9 so that the white arrow (T) on
the bottom of the blender jug points to
the open lock symbol.
3. Turn the blender jug5 clockwise until it
is firmly in place. The white arrow (T)
now points to the closed lock symbol.
Adding ingredients
• First add the liquid ingredients to the
blender jug5, and then the solid ones.
• Cut the solid ingredients into small piec-
es in advance, so that the pieces do not
get jammed in the blades.
• During blending, you can add ingredi-
ents through the refill opening3 in the
lid2:
- Reduce the speed to 1 - 2.
- Rotate the lid of the refill opening1
anticlockwise and remove it.
- Add the ingredients.
- Replace the lid1 such that the small
plastic nibs fit into the recesses at the
refill opening3.
- Turn the lid1 clockwise until it is firm-
ly in place.
Mounting the lid
NOTES:
• For safety reasons, the blending process
will only start when the lid2 is correctly
mounted.
• To make it a little easier to close the
lid2, place a few drops of cooking oil
onto a cloth and rub it over the seal4.
4. Place the lid2 slightly distorted onto the
blender jug5.
5. Rotate the lid2 clockwise until it stops.
The device is now fully assembled.
On working with the device: see “Basic op-
eration” on page 42.
__349710_711_Kuechenmaschine_B8.book Seite 41 Mittwoch, 20. Mai 2020 2:06 14