SED 3.7 G3
GB
│
MT
│
77 ■
Mains power operation
1) Insert the connector plug of the mains power adapter 0 into the
socket for mains adapter 7 on the appliance. Ensure that the
speed switch 5 is set at “0”.
2) Connect the mains power adapter 0 to a mains power socket.
The control lamp 6 glows red to indicate that the charging
process is active.
The appliance is ready for immediate use.
Battery operation
1) Insert the connector plug of the mains power adapter 0 into the
socket for mains adapter 7 on the appliance. Ensure that the
speed switch 5 is set at “0”.
2) Connect the mains power adapter 0 to a mains power socket.
The control lamp 6 glows red to indicate that the charging
process is active.
As soon as the control lamp 6 glows green the appliance is fully
charged and you can disconnect it from the mains power supply.
NOTICE
► For the initial charging, the appliance requires about 80 minutes
to fully charge.
► First recharge the appliance when the control lamps 6 indicate,
by alternately flashing red and green, that the battery charge
level is low.
IB_353054_SED3.7G3_LB5.indb 77 08.10.2020 13:27:20
To Next Page
