SED 3.7 G3
■ 80
│
GB
│
MT
7) When you are finished with the treatment, place the speed
switch 5 to “0”.
8) Clean the epilator head 2 as described in the section
“Cleaning and Care”.
9) If necessary, remove the massage roller attachment 9 and place
the protective cap 1 on the epilator head 2.
NOTICE
► Stop using the epilator head 2 immediately if it is damaged!
To order a new epilator head 2, please contact the Service
Department (see section “Ordering replacement parts”).
To replace the epilator head 2, please proceed as follows:
― Press the two restraint fixtures 3 together, and at the same
time pull the epilator head 2 upwards.
― Press the new epilator head 2 onto the appliance.
The epilator head 2 must click into place.
Cleaning and Care
RISK OF ELECTRIC SHOCK
► Before cleaning, disconnect the appliance from the mains power
adapter 0 and the mains power adapter 0 from the main power
supply.
WARNING! PROPERTY DAMAGE!
► NEVER submerse the appliance in water or other liquids!
■ After every use clean the epilator head 2 with the supplied
cleaning brush w to remove loose hairs.
■ Disinfect the epilator head 2 regularly by spraying and
cleaning it with disinfectant spray.
IB_353054_SED3.7G3_LB5.indb 80 08.10.2020 13:27:21
To Next Page
