GB
│
IE
│
7 ■
SSMS 600 E5
Assembling the wire whisk
■ Press the whisk 7 into the whisk holder 6, until it firmly engages.
■ Place the so assembled whisk 7 onto the motor block 4 so that the arrow
points to the symbol
Turn the motor block 4 until the arrow points at the
symbol
.
Operation
WARNING! RISK OF INJURY!
► Foodstuffs should not be too hot. Squirting contents may cause scalding.
NOTICE
► When you beat cream with the whisk 7 hold the container at a slant during
the beating. In this way the cream will be thicker quicker. Ensure that cream
cannot be sprayed out of the container while it is being beaten. When
whipping cream, slide the speed regulator 1 to position "Max".
When you have assembled the blender set as you wish to use it:
1) Insert the plug into a mains power socket.
2) Press and hold the switch
2 to process foodstuffs at the standard speed.
Slide the speed regulator 1 in the direction of “Max” to increase the speed.
Slide the speed regulator 1 in the direction of “Min” to reduce the speed.
3) Press and hold the turbo-switch 3 to process foodstuffs at a higher speed.
By pressing the turbo-switch 3 the maximum processing speed is available
immediately.
4) Once you are done processing the food, simply release the pressed switch
2/3.
To Next Page
Loading...
