GB/IE/NI/CY/MT 19
To empty the water tank, use a shallow bowl
that can hold more than 0.5 l of water.
Rotate the drain plug
7
(as well as the inner
plug underneath) out of the opening and let the
water drain off.
Rotate the drain plug
7
(and the inner plug
underneath) properly back into the opening.
The product can now resume operation after the
mains plug has been reconnected and the hot
air outlet hose
14
has been refitted.
4.9.1 Use permanent water drainage
If the product is mainly operated in dehumidification
mode, it is possible to let the water drain off contin-
uously and thus empty the water tank automatically.
Switch off the unit and disconnect the mains
plug from the socket.
Rotate the drain plug
10
(and the inner plug un-
derneath) out of the opening and let the water
drain off.
Now connect a suitable drain hose (not includ-
ed in the scope of delivery) to the opening.
Place the open end of the drain hose in a suitable
collection vessel or drain.
Note: Make sure that the drain hose leads as directly
as possible to the drain without kinks or knots. In this
way, the water produced during the dehumidification
process is automatically directed to the drain.
5. Protective function
5.1 Overflow protection function
When the water in the water tray exceeds the
warning level, an alarm sounds automatically and
the "FULL" indicator flashes. At this point, you must
move the drain pipe connecting the machine or the
water outlet to a drain pipe or other drain area to
empty the water. After the water has been emptied,
the machine automatically returns to its original
state.
5.2 Protective function of the compressor
To prolong the compressor's life, it has a protection
function with a 3-minute start delay after the com-
pressor has been switched off.
To Next Page
Loading...
