GB
│
IE
│
11 ■
SMK 1000 B3
NOTE
If there is dirt on or underneath the sealing
ring 8, it can be removed for cleaning:
– Pull the sealing ring 8 downwards off the
lid 9.
– Clean the sealing ring 8 in warm water
with a little washing-up liquid. Rinse off all
detergent residues and dry the sealing ring 8
thoroughly.
– Remove any dirt from the recess on the lid 9
with a damp cloth. If necessary, apply a mild
washing-up liquid to the cloth. Afterwards,
wipe with a cloth moistened only with fresh
water and dry everything thoroughly.
– Push the sealing ring 8 back onto the lid 9
so that the sealing ring 8 slides into the
recess. Make sure that the small notch on the
sealing ring 8 is wrapped around the fixing
lug on the cover 9 (Fig. 1). The flattened
side of the sealing ring 8 should lie on the
same side as the sensor 7:
Fig. 1
12) Wipe the mains cable with a damp cloth.
13) Dry all parts well before re-use.
Storage
■ Store the cleaned appliance in a clean, dust-free
and dry location.
To Next Page
Loading...
