14 GB/IE/NI
Clean the contacts on the battery and inside the battery compart-
ment before inserting!
Immediately remove drained batteries from the product.
Do not use rechargeable batteries.
Initial use
The batteries have been installed when you first purchase the prod-
uct. Before first use, remove the protective battery strips sticking
out from the battery compartment. The multi-function thermometer
will then switch on automatically.
Inserting / Replacing Batteries
Before replacing the battery, ensure that the device has been switched
off.
When the batteries become weak, the battery warning symbol will
appear on the display
. Temperature measurements will still be
possible but the batteries will have to be replaced as soon as possible.
If the battery warning symbol
and „Lo“ flash on
the display, the batteries must be replaced immediately. If
the batteries are too weak, the thermometer will switch off
automatically.
Proceed as follows to replace the batteries:
Open the screw
5
on the battery cover
4
using a cross-head screwdriver.
To Next Page
Loading...
