23 GB/IE/NI
Measuring object temperatures
To switch on the multi-function thermometer, press the ON / OFF /
MEASURE button
8
for one second.
Then press the M button
9
and the S button
7
at the same time
for 3 seconds to change to the object temperature mode.
appears
on the LCD display.
Point the sensor tip towards the object
2-3 cm
or the liquid to be measured (never
immerse in liquids!) at a distance of 3 cm
and press the ON / OFF / MEASURE
button
8
for 1 second. (never immerse
in liquids!).
Release the ON / OFF /
MEASURE button
8
. The meas-
ured value appears on the display
and the end of measurement is in-
dicated with a short beep (when
the key tone is activated). The next measurement is possible after
approx. 5 seconds.
To leave object temperature mode once more, hold the M button
9
and the S button
7
at the same time for 3 seconds again.
If you have activated Bluetooth
®
data transfer, the data will be
transferred after the measurement. The thermometer displays the
symbol for Bluetooth
®
during transfer.
Note: The „HealthForYou“ app must be activated for transfer to
occur. If the current data is not displayed on your smartphone,
repeat the transfer process as described in the chapter „transfer-
ring measured values“.
The device switches off automatically after 60 seconds, or press
the ON / OFF / MEASURE button
8
for 5 seconds to switch it off.
To Next Page
Loading...
