GB/IE 27
Operation
Operation
Synchronising transmitter / receiver
Synchronise the transmitter and receiver as follows:
As soon as the batteries are installed, the receiver enters synchronis-
ing mode.
You can also manually enter synchronising mode by holding the
synchronising button
2
for approx. 3 seconds.
The signal indicator
1
on the receiver will light on.
Press the chime button
13
, the signal indicator
11
on the transmitter
will illuminate once.
The signal indicator
1
on the receiver will then blink. This is to indi-
cate the synchronisation is successful.
NOTE: The synchronisation mode can only last for approx. 2 minute.
If you cannot synchronise your transmitter and receiver, please enter
synchronising mode again.
NOTE: Wait for approx. 2 Minutes after the transmitter and receiver
have been successfully synchronized until the signal indicator
1
on the
receiver goes out.
Setting the signal type
The receiver can indicate the reception of a door signal either optically
or acoustically or both optically and acoustically.
To Next Page
Loading...
Need help?
General
