GB/IE28
Operation
Using the signal type selector button
5
, select whether the signal
is to be indicated optically or acoustically or both optically and
acoustically.
Setting the volume
Press the volume button
3
until the desired volume is reached. There
are a total of 4 possible volume settings: very loud, loud, medium, sof
t.
Selecting the chime
Note: The doorbell has 36 different chimes.
Press the melody selection button
4
. The first audible signal sounds.
Press the melody selection button
4
again to move on to the next
audible signal.
Repeat this process until you have selected your desired audible signal.
The last-selected audible signal is automatically stored.
Troubleshooting
After the influence of extraordinary environmental conditions (e.g. a strong
electromagnetical field) the function of the item may be affected. In this
case, please take off the batteries of both appliances for approximately
2 minutes. Then proceed again as described in the section “Synchronising
the transmitter / receiver”.
To Next Page