13
Setting up and connecting
Loudspeaker System KH 2525
GB
Disposal of the packaging
The packaging protects the device from transport damage. The packaging materials
are selected from the point of view of their environmental friendliness and disposal
technology and are therefore recyclable.
The recirculation of packaging into the material circuit saves on raw material and
reduces generated waste. Dispose of packaging material that is no longer needed
according to the regionally established regulations.
NOTICE
If possible preserve the device's original packaging during the warranty ►
period so that in the case of a warranty claim you can package the device
pr
operly for return.
Requirements for the setup location
For safe and trouble free operation of the device the setup location must fulfi ll the
following provisions:
The transmission unit and the speakers must be placed on a fi rm, fl at, level ■
surface.
Do not place the de
vice in a hot, wet or very damp environment or in the vicinity ■
of fl ammable materials.
The mains po
wer socket must be easily accessible so that the power adapter ■
can be easily disconnected in an emergency.
Connecting the mains adapter
Observe the following electrical connection for safe and failure free operation of
the device:
Before connecting the power adapter ■
17
compare the connection data
(voltage and frequency) with that on the rating plate of your electric supply.
This data must agree in order to avoid damaging the device.
Make sure that the power adapter's ■
17
connection cable is not damaged and
is not laying over hot surfaces and/or sharp edges.
The power adapter's ■
17
connection cable must not be stretched too tight.
Plug the connection cable into the DC IN
11
connection and then plug the
power adapter
17
into a mains power socket.
KH2525_37971_LB4 indb Abs3 13 25 11 2009 14 15 16 Uhr
To Next Page
Loading...
