66 GB/MT
(+ or -) is correct as indicated in
the battery compartment.
Reattach the battery compart-
ment cover
29
to the battery
compartment.
Initial use
Note: The product has 3 operating
modes: cooling mode, dehumidifi-
cation mode and fan mode.
Unless otherwise described, you can
select all the settings listed below
using both the control panel
1
and
the remote control
11
(see fig. B or C
).
Each time a button is pressed, an
acoustic signal sounds as confir-
mation.
Set up the product as described
in the chapter “Setting up the
product“.
Pl
ug the mains plug
10
into a pro-
perly installed grounded power
socket. Do not use extension
leads or multi-plugs.
Point the remote control
11
in the
direction of the signal receiver
24
and make sure that there are no
obstacles between the two com-
ponents.
Note: You can control the direc-
tion of the air flow by moving the
lever on the ventilation slots
2
.
Using cooling mode
Press the POWER button
27
to switch on the product. The
product switches on and the
display
19
shows the pre-set /
last set temperature.
Press the MODE button
23
repeatedly until the mode indica-
tor
20
shows COOL. The product
is now in cooling mode.
Now set the desired temperature
using the TEMP– button
25
/
TEMP+ button
26
(tempera-
ture range: 16 °C–31 °C). The
set temperature flashes on the
display
19
and is saved after
approx. 5 seconds.
Push the SPEED button
22
to adjust the fan speed. The fan
speed indicator
17
shows the
selected speed (HIGH or LOW).
To turn off the product, press the
POWER button
27
.
Using dehumidification
mode
Note: You can remove the hot air
outlet hose
13
from the product when
operating in dehumidification mode.
For instructions on how to drain
the integrated water tank, see
the chapter “Draining the water
To Next Page
Loading...
