69 GB/MT
Pull the drain plug
8
(as well
as the inner plug beneath it) out
of the opening and allow the
water to drain (see fig. J).
Insert both drain plugs
8
back
into the opening properly. Once
the product has been connected
to the power supply and the hot
air outlet hose
13
has been re
at-
tached, it can resume operati
on.
Using continuous
water drainage
If the product is mainly being used
in dehumidification mode, it is pos-
sible to drain the water continuously
and thus empty the water tank au-
tomatically.
S
witch off the product and rem
ove
the mains plug
10
from the socket.
Pull the drain plug
8
(as well
as the inner plug beneath it) out
of the opening and allow the
water to drain (see fig. J).
Connect a suitable drainage h
ose
(not included) to the opening.
Place the open end of the drain
h
ose in a suitable collecting vesse
l
or drain.
Make sure that the drain hose
leads to the drain as directly
as possible and without kinks
or knots. This way, the water
collected during the dehumidifi-
cation process is automatically
fed into the drain.
Troubleshooting
Some errors are caused by minor
malfunctions and can sometimes be
corrected by the user. If you are still
unable to remedy the problem, con-
tact customer service. Do not repair
the product yourself under any cir-
cumstances.
Problem Possible cause Solution
The product
won't start.
The water tank is full. Empty the water tank.
The room temperature is
lower than the set tempera-
ture (cooling mode).
Adjust the temperature
setting.
To Next Page
Loading...
