Silvercrest PD-8871 - Adjusting the Air Flow; Draining the Water Tank

68 GB/MT
on automatically when the time
is up.
To cancel the timer function, press
the TIMER button
21
once.
Automatic switch-off
(sleep timer)
Push the TIMER button
21
when the product is on.
Use the TEMP– button
25
/
TEMP+ button
26
to set the
timer (1–24 hours). The set time
flashes on the display
19
.
Push the TIMER button
21
again to confirm the set time. If
the time is not confirmed and no
further entry is made, the timer
will be cancelled after about
10 seconds. The timer will start
counting down the remaining ti me
and the product will turn off au-
tomatically when the time is up.
To cancel the timer function, press
the TIMER button
21
once.
Adjusting the air flow
You can adjust the air flow man-
ually by moving the ventilation
slots
2
on the front air outlet
3
up or down.
D raining the water ta nk
T he integrated water tank
fi
lls with water in the follow-
ing situations:
– A t low room temperature and hig h
humidity, the product may not be
able to evaporate the moisture
quickly enough. If this is the case,
water collects in the water tank.
– If the product is in dehumidification
mode, it draws moisture from the
air in the room. Consequently,
water accumulates in the water
tank. When the water tank is full,
the water tank indicator (W.F)
16
lights up and the error code “E2“
is shown on the display
19
. The
product stops operating.
Proceed as follows to drain
the water tank:
Switch off the product and
remove the mains plug
10
from
the socket.
Pull the hose connector
15
off the
back air outlet
7
and remove
the hot air outlet hose
13
from
the product.
To empty the water tank, use a
floor cloth or flat bowl that can
absorb/accommodate 0.5 L of
water.