Silvercrest RT2000 - Installing the New Thermostat Head

38
G
2� Unscrew the xing element (10) of the thermostat head
and remove the thermostat head�
Installing the New Thermostat Head
To t the device to Danfoss radiator valves, you need one
of the adapters provided� To determine which adapter (14)
ts which radiator valve, please refer to Fig. 2-4 on the fold-
out page�
Caution! During assembly, be careful
not to jam your ngers between the
halves of the adapter!
Caution! The adapters supplied are
joined together with plastic tabs� Edges
which have been snapped o can be
sharp� Break out the plastic tabs carefully
and smoothen the sharp edges on the
adapter you use with a suitable tool�
The notches (13) on the circumference ensure the adapter
ts perfectly.
1� If required, slip the adapter (14) that ts the radiator
valve onto the valve until the adapter snaps into place�