Silvercrest SADH 12 C2 - Electrical Connection; Power Supply Connection Guide; Handling and Operation; Initial Setup and First Use

GB
│
IE
│
11 ■SADH 12 B2 / SADH 12 C2
Electrical connection
IMPORTANT
► Before you connect the appliance to the power supply, check to
ensure that the required input voltage as given on the type plate
tallies with that for the intended power source. To avoid possible
damage to the appliance this data must match.
► Check to ensure that the cable for the power adapter e is not
damaged and that it does not lead over hot surfaces and or
sharp edges, otherwise it could be damaged.
► Ensure that the cable for the power adapter e is not over-taut
or kinked.
♦ Connect the power adapter e to the appliance by inserting the
plug into the plug socket 8 on the underside of the appliance.
Handling and operation
Initial use
IMPORTANT
► It is possible that oil drops may cause damage to furniture
surfaces. If necessary, place a cloth under the appliance.
♦ Place the appliance on a stable and level surface.
♦ Remove the coverw and lid1.
♦ Fill the water tank3 with at least 20ml (maximum 300ml)
clean tap water using the provided measuring beaker r. Note
the maximum filling level 6 marked with MAX.
♦ Add 2–4 drops of the desired oil to the water.
♦ Afterwards, place the lid1 and coverw back on the water
tank3.
♦ Connect the mains adaptere to the mains socket.