Silvercrest SAS 7.4 LI D3 User Manual

■ 10
│
GB
│
IE
│
NI
│
CY
SAS 7.4 LI D3
Operation
CAUTION!
► The suction opening must always be open and may not be blocked.
Blockages lead to overheating and damage to the motor.
► The appliance is not protected against splashes. You should therefore only
vacuum liquid up until the dirt container
q is filled to the MAX mark!
NOTICES
► Make certain that the dust filter
0 is always inserted before using the
appliance.
1) Remove the handheld vacuum cleaner from the wall bracket
3 or, if you are
not using the wall bracket 3 remove the barrel plug 5 from the socket.
2) If required, place the appropriate nozzle in the suction opening:
– the crevice nozzle
2, to clean narrow and difficult to reach locations.
– the wet suction nozzle
1 to vacuum up liquids.
NOTE
► After you have vacuumed up liquids, immediately clean the dirt container
q.
Otherwise, bacteria or mould will build up inside! Ensure that the dust filter
bag 9 is completely dry before using the appliance again.
3) To switch the appliance on, slide the on/off switch
6 forwards. The charge
indicator lamp 7 lights up green.
4) When you have finished using the appliance, slide the on/off switch
6 to
the rear.

Silvercrest SAS 7.4 LI D3 Specifications

General

Brand	Silvercrest
Model	SAS 7.4 LI D3
Category	Vacuum Cleaner
Language	English