14 GB
Once the connection has been established, the LED will briefly flash twice
white every 3 seconds.
Please note, your communication device must support Bluetooth
®
Standard
4.0 to use all options.
If you come into range of the paired device with the headphones switched
on, a Bluetooth
®
connection will automatically be established.
You may need to approve the connection on the communication device.
Please refer to the instructions for use of the communication device on this
topic!
If you leave the range of your communication device with your headphones,
the LED will flash white once every 2 seconds. If the connection is not restored
within 5 minutes, the headphones will switch off.
The headphones may be manually switched off by holding the
button
5
for 3 seconds until acous tic signal sounds and the LED goes out.
Connecting the headphones to a second
Bluetooth
®
device
The headphones may be connected to two Bluetooth
®
communication devices
at the same time. If the headphones are already connected to a device, follow
the steps below to connect to the second device:
Activate multipoint mode by pressing and holding button
8
for 2 seconds.
Acoustic signal sounds. The first communication device (mobile phone or
computer) is disconnected.
Now connect to the second communication device via Bluetooth
®
with the
headphones. Please refer to the notes in the instructions for your communi-
cation device. Select the entry „SBKP 1 A2“ from the list of devices detected
by your computer or mobile. The second communication device is connected.
Briefly press button
8
and acoustic signal sounds. The first communi-
cation device is connected again. Now, both communication devices are
connected to the headphones simultaneously.
To Next Page
Loading...
Need help?
General
