To Next Page

To Previous Page

15 GB/IE/NI

Connecting the headphones to a second

Bluetooth

device

The headphones may be connected to two Bluetooth

communication devices

at the same time. If the headphones are already connected to a device, follow

the steps below to connect to the second device:

Activate multipoint mode by pressing and holding button

for 2 seconds.

Acoustic signal sounds. The ﬁrst communication device (mobile phone or

computer) is disconnected.

Now connect to the second communication device via Bluetooth

with the

headphones. Please refer to the notes in the instructions for your communi-

cation device. Select the entry “SBKP 2 A1“ from the list of devices detected

by your computer or mobile. The second communication device is connected

and the headphones emit a conﬁrmation tone.

Press button

for three times and acoustic signal sounds. The ﬁrst

communication device is connected again. Now, both communication

devices are connected to the headphones simultaneously.

Clearing paired devices

In paired mode (the LED will brieﬂy ﬂash white twice every 3 seconds),

press and hold

button

for 2 seconds and acoustic signal sounds.

The headphones is now in pairing mode. The LED

ﬂashes white.

Simultaneously pressing and holding button

and button

for

approx. 2 seconds. A signal tone sounds and the LED

ﬂashes red /

white in turn. The headphones are now in pairing mode again.

The memory in the headphones is cleared and it will not auto-connected to

the previous paired communication device.

Connecting the headphones through audio cable

Insert the 3.5 mm jack plug at one end of audio cable

to 3.5 mm socket

Silvercrest SBKP 2 A1 User Manual

Questions and Answers: