Silvercrest SBKP 4 A1 - Page 14

14 GB
Pairing with a new Bluetooth
®
device: Hold the button
5
for
approx. 3 seconds to turn on the product until the LED indicator
7
flashes blue and white and acoustic signal sounds. This indicates
the headphones are now in pairing mode, which remains active
for 5 minutes. The headphones will switch off if they do not detect
a Bluetooth
®
device to connect to and acoustic signal sounds.
Now connect your communication device (mobile phone or com-
puter) via Bluetooth
®
with the headphones. Please refer to the
notes in the instructions for your communication device. Select the
entry “SBKP 4 A1“ from the list of devices detected by your com-
puter or mobile.
Once the connection has been established, the LED indicator
7
will briefly flash blue twice every 5 seconds.
Please note, your communication device must support Bluetooth
®
Standard 5.0 to use all options.
If you come into range of the paired device with the headphones
switched on, a Bluetooth
®
connection will automatically be estab-
lished.
You may need to approve the connection on the communication de-
vice. Please refer to the instructions for use of the communication
device on this topic!
If you leave the range of your communication device with your
headphones, the LED indicator
7
flashes blue and white. If the
connection is not restored within 5 minutes, the headphones will
switch off.
The headphones may be manually switched off by holding the
button
5
for 3 seconds until acoustic signal sounds and the
LED indicator
7
goes out.