Silvercrest SBLL 4.2 A1 - Initial Use; Charging the Battery

SilverCrest SBLL 4.2 A1
12 - English
1 Display
2 button
3 M button
4 button
5 button
6 ON/OFF switch
7 LED
8 LINE IN jack
9 Micro-USB charging port
Initial use
Charging the battery
WARNING! Due to the high current
consumption, do not charge the speaker on
a notebook/PC but only with a suitable
mains adapter (5 V , min.
1 A; not included in the package contents).
Before initial start-up or if the integrated battery is flat,
charge the device up as follows:
 Connect the supplied USB charging cable (B) to the
micro-USB charging port (9) and a free USB port on
a USB mains adapter (not included in the package
contents).
 The LED (7) lights up orange while the battery is
charging and goes out once the battery is fully
charged. You can continue to use the speaker while it
is charging. Please note that this will slightly increase
the amount of time required to charge the device.