Silvercrest SDM 1500 D3 - Accessory Selection; Filling the Water Tank; Water Hardness and Type; Tank Capacity Limit

12 GB
 Choose the desired accessory:
Accessories for:
Suggested place
of use
Extension nozzle
13
Angle nozzle
5
Hard-to-reach areas
Scraper
6
Removing residues from
hobs
Oblong brush
7
Grout lines
Large round brush
9
Hobs, showers,
refrigerators, etc.
Small round brush
11
NOTE: The small round brush
11
is made of
copper alloy. Be careful during use not to leave
scratches on the cleaning surface.
 Put the extension nozzle
13
into the selected
accessory
5
,
6
,
7
,
9
,
11
: Place the smaller
protrusion on the extension nozzle into the arrow
on the accessory. Hold the extension nozzle
firmly. Turn the accessory anti-clockwise until the
arrows on extension nozzle and accessory are
aligned (fig. A).
Upholstery attachment installation
 Align the locking hole of the upholstery
attachment
10
with the release lever
17
of the
handheld unit
22
/extension hose
2
.
 Push in the upholstery attachment
10
until it locks
in place.
 Choose the desired accessory:
Accessories for:
Suggested place
of use
Upholstery
attachment
10
Microfiber cover
8
Sofas, tablecloths,
garments
Squeegee attachment
12
Shower screens,
mirrors, glass
 Operation
 Filling the water tank
mDANGER! Risk of electric shock! Always
disconnect the power plug
23
from the wall
socket before filling the water tank
18
.
mCAUTION! Fill the water tank
18
with tap water
or distilled water without any additives. If your
tap water is hard, use distilled water. Where the
water is moderately hard, mix distilled water and
tap water (ratio of 1:1).
NOTES:
 Checking the water hardness: Use a test strip or
ask the water supplier.
 Do not exceed the water tank's
18
maximum
capacity of 350 ml.
 Open the water tank cover
18
.
 Use the filling cup
4
and the funnel
3
to fill the
water tank
18
.
 Close the water tank
18
.
 Turning on/off
 Connect the power plug
23
with a suitable wall
socket.