Silvercrest SDMF 1300 B2 - Standby Mode; Filling;Draining the Water Tank; Removing;Attaching the Brush; Steam Smoothing Clothes

11GB/IE/NI
 Standby mode
 When the steam button [3] is released, the
product stops heating automatically after
15minutes and the red LED
[] flashes.
 Filling/draining the water
tank
DANGER! Risk of electric shock!
Before filling the water tank
[5]: Disconnect
the power plug
[8] from the power outlet.
NOTES:
 Fill the water tank
[5] with tap water or
distilled water without any additives. Use the
following mixtures according to your regional
water hardness:
Water hardness Water
Soft Tap water
Medium hard Distilled and tap
water (Ratio: 1:1)
Hard Distilled water
Your local water utility can inform you
about your region's local water hardness.
 The water tank
[5] has a filling capacity of
approximately 250 ml.
 The MAX marking
[7] for the maximum
filling capacity applies when the water
tank
[5] is positioned vertically.
 Filling the water tank
[5]: Press the
release buttons
[9]. Pull the water tank out
of the product (Fig. C).
Pour water via the water tank opening
[4]
into the water tank. Do not exceed the MAX
marking
[7].
Close the water tank opening
. Wipe off
water splashes. Reinsert the water tank into
the product (Fig. D). The water tank clicks
into place audibly.
 Draining the water tank
[5]: Remove
the water tank. Pour out the water through
the water tank opening
[4].
 Removing/attaching the
brush
(Fig. E)
m
WARNING! Risk of burns! Wait
until the product has cooled down before
removing or attaching the brush
[2].
NOTE: The product can be used with or
without the brush
[2].
 Removing the brush
[2]: Carefully pull
the brush off the lower bracket.
 Attaching the brush
[2]: Press the
brush onto the steam nozzles
[1]. The lower
bracket must engage.
 Steam smoothing clothes
 Preparation: Hang the clothes on a
clothes hanger or a rail.
m
ATTENTION! Risk of property
damage! Before steam smoothing: Check
the ironing instructions to determine if the
clothes are suitable for use with this product:
Ironing instructions Suitable
Yes
Yes
Yes
No
Ironing instructions can often be found on a
label sewn to the clothes.
If there should be no label: First try steam
smoothing on an inconspicuous piece of the
clothes.
m
ATTENTION! Risk of property
damage!
Do not treat leather, velvet, impregnated
furniture or materials that are sensitive to
steam.
Do not touch materials that are sensitive
to heat (such as synthetic materials such
as polyamide or rayon) directly with the
hot steam nozzles
[1]. Only use the steam
smoothing function.