Silvercrest SDMF 1300 B2 - Steam Smoothing Curtains and Upholstery; Stop Steam Smoothing

12 GB/IE/NI
 Connect the power plug
[8] to a suitable
power socket. Set the on/off switch
[] to the
I position.
LED []
Description
Flashing (blue) Product warming up
Continuously on
(blue)
Product ready for
steam smoothing
 Ejecting steam: Push in
[3].
m
WARNING! Risk of burns!
When steam smoothing, always point the
steam nozzles
[1] towards the clothes
(Fig. F).
Never steam smooth clothes while they are
being worn.
Allow the clothes to cool down on a clothes
hanger before wearing them.
 Slightly stretch the clothes with one hand.
Steam smooth the clothes by moving over
them with the brush
[2]. Keep your hands
away from the steam.
 Apply light pressure on the clothes with the
brush
[2]. Move the brush back and forth in
a straight line.
NOTES:
 After washing: Hang up the clothes (e.g. on
a clothes hanger). The clothes thus dry with
fewer creases.
 The product cannot produce strong creases
or a smooth, ironed appearance. For such
needs, an iron is more suitable.
 While steam smoothing: The clothes absorb
moisture. Allow the clothes to dry completely
before storing them in your wardrobe.
Continuous steam operation
During continuous operation, hot steam exits out
of the steam nozzles
[1] without the need to keep
pressing in
[3].
Continuous steam operation
Start continuous
operation
Press in
[3].
Movedown the lock
[3].
Stop continuous
operation
Move up the lock
[3].
 If water drips out of the steam nozzles
[1]:
Pull up the lock
[3]. Release [3]. The
products heats up now.
NOTES:
 When the water tank
[5] is emptied during
continuous steam operation, the product
turns off automatically after approx.
40 seconds. The red LED
[] flashes. Release
[3]. Fill water into the water tank (see
“Filling the water tank”).
 The product turns back on automatically
when the steam button
[3] is pressed.
 Steam smoothing curtains
and upholstery
 Remove creases and wrinkles from curtains
and upholstery by hanging these over a
railing and then tightening them.
 Before steam smoothing: Always carry out a
test on an inconspicuous piece of the fabric.
 Steam the curtains/upholstery (see “Steam
smoothing clothes”).
 When using the product horizontally: Hold
the product vertically from time to time to
maintain the maximum steam power.
 Stop steam smoothing
 Move up the lock [3], if applicable. Release
[3].
 Place the product, with its base
[6], on a flat
and stable surface.
 Set the on/off switch
[] to the O position.
Disconnect the power plug
[8] from the
power socket.
NOTE: When [3] is released, the product
stops heating automatically after approx.
15minutes and red LED
[] flashes.
 Let the product cool down (for approx.
15 minutes). Do not leave the product
unattended while it is still hot.
 Empty the water tank
[5] after each use to
prevent limescale (see “Filling/draining the
water tank”).