Silvercrest SDR 1100 B2 - Operating the Appliance

GB
│
IE
│
NI
│
11 ■
SDR 1100 B2
Operating the appliance
1) Insert the plug into a mains power socket.
The red control lamp
4
lights up to indicate that there is a connection to
the mains electricity.
2) As soon as the appliance is ready to use, the green control lamp
5
lights
up. The red control lamp
4
stays lit.
NOTE
► While heating up, steam may occasionally escape from the steam nozzle
6
.
3) Press the steam lever
downwards. Steam comes out of the steam nozzle
6
.
If the steam pressure drops, the green control lamp
5
will go out.
Release the steam lever
until the green control lamp
5
comes back on.
NOTE
► If water drips out of the steam nozzle
6
during operation or the steam
pressure falls, release the steam lever . The appliance needs to heat up
again. Wait until the green control lamp
5
lights up again.
► The steam cleaner has a thermal cut-out. It switches itself off automatically
in case of overheating (e.g. due to an empty water tank). If this happens,
pull out the mains plug and refill the water tank
3
.
WARNING! RISK OF INJURY!
► If you stop working for an extended period of time and leave the appliance
switched on, steam may occasionally escape even though the steam lever
is not pressed.