17 GB/IE/NI
Insert four batteries type 1.5 V LR6 AA. Ensure correct polarity.
Note the markings inside the battery compartment
6
.
Reinstall the battery cover until you hear it lock into place to close
the battery compartment
6
.
Note: To see the battery status, press the Menu / Info button
9
on
the colour LCD
1
several times (see chapter “Displaying informa-
tion in the colour LCD
1
“). The battery level is shown in percent.
Initial use
Switching the product on and off
The product will only display the clock, date and alarm times in standby
mode when using the product with the power supply
15
. When battery
powered, the colour LCD
1
will be blank until the product is switched
on with the
button
8
.
Switching on / off on mains power:
Fully extend the antenna
7
for good reception.
Set the main switch
3
on the right side of the product to the “On“
position. The product is now in standby mode. The colour LCD
1
shows the current date and time, as well as the alarm settings for
alarm 1 and alarm 2.
Press the button
8
to switch on the product. When using the
product for the first time it will automatically scan for DAB+ stations
after being switched on. The progress bar in the colour LCD
1
in-
dicates the progress of the DAB+ station scan. The number above
the progress bar indicates how many DAB+ stations have been found.
After the DAB+ station scan has completed, the product will select
the first available DAB+ station and start playing it. By default, the
DAB+ stations are listed in numerical and alphabetic order.
To Next Page
Loading...
Need help?
General
