36 – English
8. Installation and initial use
Remove all packaging materials.
Before the first and each subsequent use, clean all loose parts (lid (14) and splash
guard (4), stirrer (13) and accessories), as well as the aluminium container (12) in the
appliance with a soft cloth and standard washing-up liquid. To make cleaning easier,
tilt the appliance up by 45° and wipe the aluminium container out (12) (Fig. F).
Allow everything to dry thoroughly.
Place the ice-cream maker onto a level, non-slip and heat-resistant surface.
Attach the lid (14) to the motor block (15) and push it forwards until it locks into place
(Fig. D).
Insert the stirrer into the drive shaft in the motor block (15) (Fig. E).
8.1. Using the ice-cream maker
ATTENTION!
Possible damage to the appliance!
Damage to the appliance caused by improper handling.
Do not store finished ice cream in the aluminium
container (12) under any circumstances. Use a suitable
deep freeze container.
The appliance is driven by an electric motor. This can lead to a slight smell
during initial operation. This smell is normal and is not a sign of a
malfunctioning appliance.
Ensure that there is adequate ventilation.
Fill the aluminium container (12) in the ice-cream maker with ingredients.
Use the supplied measuring cup or spoon for measuring out the ingredients.
Observe the filling volume of 400ml.
Place the fully assembled lid onto the housing (11) with the contacts (3) to the right of
the locking tab (5) so the stirrer (13) is inside the aluminium container (12).
Turn the lid clockwise whilst pushing down gently until it locks into place and the
contacts (3) on the lid are touching the contacts (7) on the ice-cream maker (Fig. G).
Connect the appliance to a properly installed mains socket. The local mains voltage
must correspond to the technical data for the appliance.
Use only the mains adapter supplied.
As soon as the plug is connected to the mains socket, the appliance will beep and the
button (18) will light up in red.
To Next Page
Loading...
Need help?
General
