47 GB/IE
Replace the shaving foil frame
3
with a new one.
Press both release buttons for the shaving head
5
(see Fig. I).
Hold the cutter block
20
between your thumb and forefinger and
pull it carefully off the razor (see Fig. G). Make sure that the
spring that is located between the cutter block
20
and the white
bracket does not fall out.
Hold the new cutter block
20
between your thumb and forefinger
and guide it carefully into the white bracket. Push it down as far
as it will go, until it audibly clicks into place on the cutter block
mount
21
.
First put the new shaving foil frame
3
back on the product,
followed by the shaving head
4
.
Troubleshooting
Fault Possible causes Action
No function. The battery may not
be charged.
Recharge the product.
Cutting performance
is deteriorating.
Hair may be stuck in-
side the cutter block
20
or hair clipper
22
.
Clean the product, as
described in the cor-
responding chapter.
Battery cannot be
charged or the bat-
tery performance is
very low.
The battery have
reached the end of its
service life.
The product must be
disposed properly as
described in the corre-
sponding chapter.
To Next Page
Loading...
