Silvercrest SFR 3.7 A1 - Page 46

46 GB/IE
Wet cleaning
Press the release buttons
2
and pull off the shaving head
4
.
Clean the shaving head
4
under running water. Allow the water
to flow through the shaving head
4
from the inside to the outside.
Allow the shaving head
4
to dry completely.
Re-attach the shaving head
4
to the product so that it clicks into
place (see Fig. E).
Replacing the shaving foil frame and the
cutter block
Note: You can place a repeat order online for the shaving foil frame
3
and the cutter block
20
under the item number 430461_2301 on the
website www.optimex-shop.com.
Do not use the product if the shaving foil
1
is
damaged. If
- you notice any damage,
- your skin hurts when shaving,
- you do not get a clean shave,
and this cannot be remedied by oiling the shaving foil
1
and the
cutter block
20
(see chapter “Cleaning and care“), then the shav-
ing foil
1
and the cutter block
20
must be replaced.
The amount of wear and tear depends on the usage intensity, but
in general the components must be replaced after approximately
one year.
Press both release buttons for the shaving head
5
and pull off
the shaving head
4
(see Fig. I).
Press both release buttons for the shaving foil frame
2
and pull
the shaving foil frame
3
off the product (see Fig. I).