Silvercrest SFR 37 A1 - Wet Shaving Guide; Long Hair Trimmer; Designer Stubble Attachment; Cleaning Indicator

9
GB
• Stretch your skin in complicated areas,
such as the chin, to achieve better re-
sults.
• Switch off the device after shaving,
clean the parts carefully (chapter
"Cleaning and maintenance of the de-
vice" on page 10) and place the pro-
tective lid|10 onto the shaving head|3
to protect the shaving foils|1 and the
long hair trimmer|11.
Wet shaving (only for battery
operation)
DANGER! Risk of electric
shock!
~ The hand-held device and the plug-in
power unit|13 are not waterproof.
Wet shaving is only allowed
when us-
ing battery power.
WARNING! Risk of material damage!
~ For wet shaving use shaving foam or
lather only; never use shaving gel or
shaving cream. This could adhere to
the cutter blocks|12.
• Before shaving, smooth a thin layer of
shaving foam on your face.
• Shave your face as described in the
chapter "Dry shaving (Rechargeable
battery and mains operation)".
• If shaving foam should clog the shav-
ing head|3, clean the shaving head
under running water (chapter "Clean-
ing and maintenance of the device" on
page 10).
Cutting long hair
Use the long hair trimmer|11 on the back
of the shaver to shorten your beard and
sideburns.
1. Take off the protective lid|10.
2. Push the long hair trimmer|11 up.
3. Switch on the shaver with the on/off|6
switch.
4. After use, switch the device off, slide
the long hair trimmer|11 back to its
original position and clean the device
(chapter "Cleaning and maintenance
of the device" on page 10).
Designer stubble
NOTE: depending on beard growth and
shaving, the appearance of a designer
stubble can vary greatly.
To maintain a designer stubble look, shave
dry with an attached protective lid|10 reg-
ularly. In this case, the protective lid acts as
a designer stubble attachment.
• Shave your face as described in the
chapter "Dry shaving (Rechargeable
battery and mains operation)".
Cleaning symbol
The device's built-in timer adds up the shav-
ing times. After 30 minutes of shaving time
the cleaning symbol on the display|7
begins to flash. It is a reminder to clean the
device regularly. If you switch off the device
while the cleaning symbol is flashing, the
timer will start back at the beginning when
counting the shaving time.
BB*5$B+HUUHQUDVLHUHUB%ERRN6HLWH)UHLWDJ-XQL