Silvercrest SFS 18 A1 User Manual

SilverCrest SFS 18 A1
English - 9
Prior to use
The remote control is powered by 2 batteries of type AAA,
LR03, 1.5V. These are supplied.
In its original state, the
batteries are already inserted
in the battery compartment. To
use the device for the first time,
you only have to remove the
plastic strip which is inserted
between the battery and the
battery contacts. Proceed as
follows:
1. Open the battery
compartment
2. Remove the plastic strip
Inserting the batteries
Open the battery compartment
on the rear of the remote control
by removing its cover in the
direction of the arrow.
Insert the batteries with the
correct polarity as shown in the
adjoining illustration. The
correct polarity is illustrated in
the battery compartment and on
the batteries. Close the battery
compartment.
When the performance of the
remote control decreases,
replace the batteries with new
batteries of the same type. The
device does not indicate when
the battery capacity is
exhausted.
Programmed codes are stored permanently
and are not lost when the batteries are
changed.

Silvercrest SFS 18 A1 Specifications

General

Brand	Silvercrest
Model	SFS 18 A1
Category	Remote Control
Language	English