Silvercrest SFS 18 A1 User Manual

SilverCrest SFS 18 A1
12 - English
code is confirmed by the LED flashing rapidly 3 times.
The LED then lights up continuously again.
4. Repeat the procedure described in section 3 to set
other buttons on your remote control for seniors.
5. To save your entries and exit the learning mode, press
the device button, for example, "A" (6), again.
The learning mode is exited automatically if no entry is
made for 14 seconds.
Reading the programmed code
It is possible to read the code which is currently
programmed for device "A" or "B". To do so, you must press
a device button and, with a short delay, one of the number
buttons 1-4. Then hold down both buttons for approximately
2 or 3 seconds. Count how often the corresponding LED
flashes in each case.
Example for device "A" (6)
Sample code: 1268
1. For the thousands digit, press “A” (6) and “1”> LED (4)
flashes once
2. For the hundreds digit, press "A" (6) and "2"> LED (4)
flashes twice
3. For the tens digit, press "A" (6) and "3"> LED (4) flashes
6 times
4. For the single digit, press "A" (6) and "4"> LED (4)
flashes 8 times
All on/All off function
If you have programmed your remote control to operate 2
devices (A and B), this function allows the simultaneous
switching on or off of both devices with just the touch of a
button. To do so, hold down the On/Standby button (1) for
approximately 3 seconds. Both programmed devices are
now switched on or off.
Factory settings
You can reset the remote control to its factory settings. To do
so, press the buttons "A" and "0" simultaneously and hold
them down for more than 3 seconds.
Please note that all codes that were programmed and set
will be lost.

Silvercrest SFS 18 A1 Specifications

General

Brand	Silvercrest
Model	SFS 18 A1
Category	Remote Control
Language	English