US - EN │ 17 ■
▯ To cancel the synchronization between
transmitter and receiver, press and hold the
synchronization button 6 on the receiv-
er for about 5 seconds.
▯ Pull the receiver out of the power socket
and wait for about 10 seconds to clear all
connections between the transmitter and the
receiver.
Mounting the transmitter
♦ Select a suitable position for the transmitter,
close to your front door.
♦ Mark the positions for the required drill holes
with the help of the mounting plate q and
drill the holes for the supplied anchors r
(5mm (3/16") drill).
♦ Push the anchors into the drill holes and
screw the mounting plate qonto the wall
using the screws t.
♦ Push the transmitter onto the mounting plate q
until it clicks audibly into place.
To Next Page
Loading...
Need help?
General
