■ 8
│
GB
│
CY
SFW 350 C1
Assembling the kubbe attachment
Unfold the fold-out side. There you will find the step-by-step illustrations for as-
sembling the appliance.
1) Remove the meat grinder casing as described under “Assembling the
meat grinder”.
2) Disassemble any attachments that might be fitted and clean the meat grinder
casing .
NOTICE
► For the kubbe attachment !, the cross blade with the spring is not
required! If need be, remove them both from the meat grinder casing .
3) Coat all metal parts with cooking oil.
4) Insert the two plastic parts of the kubbe attachment ! so that the fixings on
the bottom kubbe attachment ! ring are located in the openings in the meat
grinder casing .
5) When everything has been attached correctly, screw the ring clamp back
on hand-tight.
6) Assemble the meat grinder casing as described under “Assembling the
meat grinder”.
Assembling the biscuit attachments
Unfold the fold-out side. There you will find the step-by-step illustrations for as-
sembling the appliance.
1) Remove the meat grinder casing as described under “Assembling the
meat grinder”.
2) Disassemble any attachments that might be fitted and clean the meat grinder
casing .
NOTICE
► For the biscuit attachment , the cross blade with the spring is not
required! If need be, remove them both from the meat grinder casing .
3) Coat all metal parts with cooking oil.
4) Pull the pattern strips away from the front of the biscuit attachment .
5) First place the plastic disc and then the metal disc of the biscuit attachment
into the meat grinder casing (see fold-out side). Insert the biscuit attach-
ment . so that the fixings on the biscuit attachment . are located in the
openings in the meat grinder casing .
6) After everything has been correctly assembled, screw the ring clamp
back on hand-tight.
To Next Page
Loading...
