Silvercrest SHBS 3.7 D5 - Cleaning and Care; Shaving (Contours); Trimming Nose and Ear Hair; Trimming the Hairline

26
GB
6.6 Trimming the hairline
Precision trimmer attachment5
• Use the precision trimmer attachment5
to shorten and shape moustaches,
whiskers, sideburns or eyebrows.
• Put the edge of the attachment at the de-
sired hairline height and move the hair
and beard trimmer6 downwards.
6.7 Shaving (contours)
Shaving attachment4
NOTES:
• Your skin must be clean and dry.
• The shaving attachment4 is only suita-
ble for shaving hairlines.
• Hold the hair and beard trimmer6 at a
right angle to the skin surface and gen-
tly guide it over your face.
• Shave against the direction of your
beard growth.
• Stretch your skin in complicated areas,
such as the chin, to achieve better re-
sults.
6.8 Trimming nose and ear
hair
Nose/ear hair trimmer attach-
ment
14
• Insert only the metal tip slowly into a
nostril or an ear.
• Slowly move the hair and beard trim-
mer6 with a circular motion to trim the
hair.
7. Cleaning and care
DANGER! Risk of electric
shock!
~ Unplug the power unit12 from the wall
socket before cleaning the hair and
beard trimmer6 and the battery charg-
er13.
WARNING! Risk of injury!
~ Always switch the hair and beard trim-
mer6 off before cleaning.
WARNING! Risk of material damage!
~ Do not use any astringent or abrasive
cleaning agents.
NOTE: clean and oil the device after every
use.
Hair and beard trimmer 6 and bat-
tery charger
13
• Wipe the casing of the hair and beard
trimmer and the battery charger with a
damp cloth.
Comb attachments1,2,3
• Remove the comb attachment. Rinse the
comb attachment with water and let it
dry before using it again.
Hair trimmer, beard trimmer and
precision trimmer attach-
ments
15, 16,5
1. Figure A: remove the attachment from
the hair and beard trimmer6 by press-
ing it with the thumb towards the rear.
2. Remove the hair remnants from the at-
tachment using the cleaning brush19
included in the delivery.
3. Apply a few drops of blade oil 18 to the
cutting edge of the attachment. Using a
soft cloth, wipe off the surplus oil, if nec-
essary. Only use acid-free oil, such as
e.g. sewing machine oil.
__390160_2201_B8.book Seite 26 Freitag, 6. Mai 2022 2:56 14