Silvercrest SHBS 3.7 D5 - Reordering Parts; Storage

27
GB
Nose/ear hair trimmer attach-
ment
14
• Remove the nose/ear hair trimmer at-
tachment14. Rinse it with water and let
it dry completely before using it again.
Shaving attachment4
WARNING!
~ Do not detach the shaving foil from the
shaving foil frame, and do not clean it
using the cleaning brush19.
NOTE: from time to time, oil the cutting
blade with a few drops of acid-free oil (e.g.
sewing machine oil). Attach the shaving at-
tachment to the hair and beard trimmer6
and let it run for a few seconds without using
it. Using a soft cloth, wipe off the surplus oil,
if necessary.
1. Remove the shaving attachment4.
2. Press the button on the side of the shav-
ing attachment and remove the shaving
foil frame. While removing the shaving
foil frame, only hold it at the side and
do not press against the shaving foil.
3. Clean the cutting blade using the in-
cluded cleaning brush19.
4. Clean the shaving foil in the shaving
foil frame under running water and al-
low it to dry completely before putting
it back on the shaving attachment4.
5. Put the shaving foil frame back onto the
shaving attachment 4 . While attaching
the frame, make sure that the fastening
tabs on the shaving foil frame fit into the
appropriate recesses on the shaving at-
tachment, and press the shaving foil
frame gently downwards until it audibly
locks into place.
8. Storage
• For storage …
… put the hair and beard trimmer6 in
the battery charger13 or
… use the included storage bag21.
9. Reordering parts
Accessories for the hair and beard trimmer
5-in-1 SHBS3.7D5 can be reordered.
Online ordering
shop.hoyerhandel.com
1. Scan the QR code with your smart-
phone/tablet.
2. The QR code will take you to a website
where you can reorder.
__390160_2201_B. Seite 2 Freitag, 6. Mai 2022 2:56 1