Silvercrest SHI 1.5 A1 - Preparations; Removing;Attaching Brush Pads

SHI 1.5 A1
GB
│
IE
│
NI
│
7 ■
Preparations
Removing/attaching brush pads
You will have to remove the brush pad  to insert batteries  or
to clean the brush pad .
1) To remove the brush pad  press the release  towards
and retain it in this position.
2) At the same time, pull the brush pad  upwards on the side
where the release  is located.
3) You can now completely remove the brush pad .
4) To replace the brush pad  again, press both catches  into
the recesses on the hand unit .
5) After this, press the other side down so that the lock  engages.
The release  must then be in the
position.
_290971_SHI1.5A1_LB6.indb 7 21.07.17 09:2