EasyManuals Logo

Silvercrest SHLF 2000 D2 User Manual

Silvercrest SHLF 2000 D2
113 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
14 GB/CY
Turning on the product
Connect the power plug[] to a suitable
socket-outlet.
Activating the standby mode: Set the on/off
switch
[] to I. A short beep sounds. The
display
[6] shows the room temperature []
and the
timer indicator [] 0:00 flashes.
Turning on the product: Press
[8][]. The
product switches to fan mode.
NOTE: When the product is in operation, the
control lamp
[] is lit.
Turning off the product
Switching to standby mode: Press [8][].
NOTE: The fan continues to run for about
another 4 to 5 seconds. Afterwards, the
product turns off and the control lamp
[] goes
out.
Turning off the product fully: Set the on/off
switch
[] to 0.
Control panel / Remote control
Press the buttons on the control panel[1] or
use the remote control
[] to make settings:
NOTE: In standby mode, no settings can be
made. First, switch on the product by pressing
[8][].
Button Setting
[3] []
Timer
[4] []
Swivel function
[5] []
Operating mode
[7] []
Increase value
[8] []
Standby/operation
[9] []
Decrease value
Selecting an operating mode
Switching the mode: Repeatedly press
[5][] until the desired operating mode
indicator
[] is shown in the display[6]:
Display Operating mode
Fan
In fan mode, no heating level is
activated.
Half heating level
50 % heating power
Full heating level
100 % heating power
Automatic heating level
The product automatically adjusts
the heating level to the ambient
temperature.
Frost protection
At room temperature under
+6 °C, the product turns on
automatically.
The product heats the room
until the temperature exceeds
+12 °C.
At a temperature of +12 °C, the
product turns off automatically.
NOTES:
Whether heating level
or is the
appropriate selection, depends on the room
size. We recommend first operating the
product on heating level
.. Switch to heating
level
if the heat output on heating level is
not sufficient.
The operation mode is memorized when the
product is switched to standby mode. When
the product is switched on again, the previous
operation mode will be recalled.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Silvercrest SHLF 2000 D2 and is the answer not in the manual?

Silvercrest SHLF 2000 D2 Specifications

General IconGeneral
BrandSilvercrest
ModelSHLF 2000 D2
CategoryHeater
LanguageEnglish

Related product manuals