15GB/CY
Setting the desired
temperature
NOTES:
The temperature values are displayed in
Celsius (°C).
The target temperature
[] and the room
temperature
[] are shown in the display[6].
Select a heating operating mode ( , or
) with [5][].
Set the desired temperature
[] with [7][]
and [9][].
As soon as the room temperature
[] reaches
the set target temperature
[], the product
switches off automatically.
The product automatically switches back on
again as soon as the room temperature
[]
falls below the set target temperature
[]. In
active heating operation, the control lamp
[]
is lit.
Swivel function
The built-in swivel function allows the product to
swivel to the left and right. The air flow is thereby
evenly distributed in the room.
Turning the swivel function on/off: Press
[4][].
When the swivel function is active,
[] is
shown in the display
[6].
Timer
The timer turns off the product automatically after a
preset time elapses.
Setting the timer: During operation, press
[3][].
The hour display starts flashing.
Set the hours with
[7][] and [9][].
Press
[3][] to confirm.
The minute display starts flashing.
Set the minutes with
[7][] and [9][].
Press [3][] to confirm or wait for
5 seconds.
When the timer is set,
and the remaining
time
[] are shown in the display[6].
After the set time runs down, the product turns
off automatically.
NOTE: When the product has been turned off
by the timer, End is shown in the display
[6].
If no button is pressed within 5 seconds after
[3][] was pressed, the timer setting will
be aborted.
Overheating protection
The product is equipped with overheating
protection, which automatically switches off
the heating element in the event of internal
overheating. The fan continues to run to speed up
the cooling of the product. As soon as the product
has cooled down, the heating element switches on
again automatically.
Replacing the battery
Replace the remote control’s [] battery as soon as
the signal reception weakens.
Follow the illustration on the back of the remote
control
[].
Slightly press side lock of the battery
compartment
[] to pull it out (Fig. C).
Remove the old battery.
Insert a new battery (type CR2025) with
correct polarity.
Push the battery compartment
[] shut.
Transport
m
WARNING! Do not move the product while it
is in operation or cooling down.
Carry the product by the provided handle
[]
only.
To Next Page
Loading...
Need help?
General
