Silvercrest SKMK 1000 A1 - Before First Use

GB
│
IE
│
NI
│
CY
│
7 ■
SKMK 1000 A1
Before first use
WARNING
► Hot steam escapes from the steam outlet openings 2 of the appliance lid!
There is a risk of scalding!
► Never open the appliance lid while brewing is in progress! Bursts of hot
steam may be released or hot water may spray out. There is a risk of
scalding!
► The hotplate 7 under the coffee pot 6 is heated strongly during the
brewing/keeping warm process. There is a risk of burns!
CAUTION – PROPERTY DAMAGE!
► Never fill the water tank 0 to more than the total amount required for
10 cups (MAX marking).
► There is a small hole 3 on the back of the appliance. This is a water over-
flow that prevents too much water from being poured into the appliance. If
the water level exceeds the MAX mark, the water will escape through the
water overflow 3 onto the worktop.
► If the appliance is moved with a full water tank 0 (10 cups of water),
water may run out through the water overflow 3.
► Never fill the water tank 0 with less than 2 cups of water. Use the fill level
indicator 4 on the water tank 0 for reference.
1) Place the appliance on a level and heat-resistant surface.
2) Rinse the coffee pot 6 thoroughly with water and place it in the appliance.
3) Open the appliance lid by pulling it upwards by the handle 1.
4) Remove the filter basket q from the filter basket holder 9.
5) Rinse the filter basket q in fresh water and replace it in the appliance.
6) Fill the water tank 0 with water for 10 cups.
7) Close the appliance lid.
8) Insert the plug into a mains power socket.
9) Press the
button 5. Wait a moment. The button 5 lights up.
The brewing process begins.
10) Wait until the brewing process is completed and press the
button 5
again to turn off the appliance.