GB
│
IE
│
NI
│
9 ■
SKS 4 A1
Battery operation
NOTE
► For battery operation, use 3 x 1.5 V AA/Mignon/LR6 batteries (included).
► When the battery level is low, the
symbol flashes on the display .
Replace the batteries as soon as possible.
♦ Using a Phillips screwdriver, loosen the screw of the battery compartment
on the back of the appliance.
♦ Remove the cover of the battery compartment
.
♦ Insert the batteries into the battery compartment
. Place the batteries into
the battery compartment
as indicated on the polarity diagram.
♦ Close the cover of the battery compartment
and tighten the screw again.
Mains power operation
♦ Connect the supplied mains adapter
6to the connection socket of the
appliance and to a mains socket.
After the power supply has been established, both halves of the illuminated
area
illuminate briefly, and the display switches on and shows a face.
The appliance is in standby mode.
Inserting and changing the motif disc
The motif discwith one image 0is provided for use as a night light.
The motif disc
with two images .is intended for use as a sleep trainer.
♦ Place the motif disc in the depression so that the two tabs of the motif disc
slide into the two recesses on the edge of the illuminated area
.
♦ Turn the motif disc clockwise until it sits firmly on the front of the illuminated
area
.
♦ Turn the motif disc anticlockwise to remove it.
NOTE
► Store the unused motif disc in the storage compartment
at the rear of
the appliance. To do this, push the motif disc from above behind the two
tabs.
To Next Page
Loading...
Need help?
General
