#
Overview of equipment
Front side of the receiver
Rear side of the receiver
Remote control
Overview of equipment
Front side of the receiver
1 – Infrared sensor for the signal of the remote control
2 LED display Shows channel location
3 LED POWER LED is illuminated if the receiver is switched on or in
standby mode
4 OK Conrm
5 MENU Invokes main menu
6 VOL + Increases volume, cursor moves to the right
7 VOL – Decreases volume, cursor moves to the left
8 CH + Switches to the next higher channel location
Cursor moves up
9 CH – Switches to the next lower channel location
Cursor moves down
10 STANDBY Switches on and switches to the standby mode
The default settings will be restored if you keep this key
pressed for more than 10 seconds.
Caution! By doing this, your personal settings will be deleted.
Rear side of the receiver
1 LNB IN LNB connection for the antenna cable
2 IF OUT LNB connection for a second satellite receiver
3 VCR SCART connection for the video set
4 TV SCART connection for the TV set
5 100 – 240 V~ Mains connection
50/60 Hz, 20 W
6 ON/OFF Mains switch
7 S-VHS S-Video connection
8 COAXIAL Digital coaxial audio output
9 OPTICAL Digital optical audio output
10 RS 232 Serial port
11 VIDEO Video connection
12 AUDIO L Left stereo audio connection
13 AUDIO R Right stereo audio connection
Faulty-Description:
GUARANTEE
Sender please use block-writing in boxes with CAPITAL LETTERS
Surname
Firstname
Street
Postcode and city
Telefon no. with areacode
Signature of buyer
PLEASE CUT THIS CARD AND ENCLOSE IT TO THE RETURNING GOOD
COMAG
Service Centre
Unit 1 Longs
Industrial Estate
Englands Lane
Gorleston Great
Yarmouth
Norfolk NR31 6BE
Service-Hotline:
00 44 (0) 8708 900137
E-mail:
info@comag-ag.co.uk
Model / Type: SL 65
•
•
f
r
o
m
p
u
r
c
h
a
s
e
-
d
a
t
e
•
•
•
•
3
6
m
o
n
t
h
s
•
•
Guarantee