GB
│
CY
│
13 ■
SLR 30 A1
Replacing the filter
RISK OF ELECTRICAL SHOCK!
► Always switch off the appliance and unplug it
from the mains before chang-
ing the filter!
NOTE
► The interval for a filter change is approx. 1500 operating hours.
► Information on ordering replacement filters can be found in the next section
Ordering spare parts.
When the filter
8 has reached the end of its life and is used up, this is indicated
by the flashing of the filter change button 3. To change the filter 8 and
replace it with a new filter 8, proceed as follows:
1. Switch off the appliance and pull out the mains plug.
2. Turn the appliance upside down to access the bottom of the unit.
3. Turn the housing cover
9 on the bottom of the appliance a little way
anticlockwise in the OPEN direction to open it (see fig. 3). Then remove
the housing cover 9 from the appliance.
Fig. 3 Fig. 4
4. Remove the filter
8 from the appliance and insert a new filter 8 into the
appliance.
5. Replace the housing cover
9 onto the appliance. Pay attention to the recesses
on the edge of the lid opening.
6
. Turn the housing cover
9 clockwise a little way in the CLOSE direction un-
til it is closed (see fig. 4). Turn the appliance back over
.
7. Press the filter change button
3 for about 3 seconds to confirm the filter
change and reset the filter timer. You will hear a beep, the filter change button
3 flashes three times and then goes out.
To Next Page
Loading...