Silvercrest SLR 30 A1 - Troubleshooting

GB
│
CY
│

15 ■
SLR 30 A1
Troubleshooting
The following table will help you to identify and rectify minor malfunctions. If the
solutions presented below do not resolve the problem, please contact Customer
Service (see section Service).
Fault Cause Remedy
The appliance will
not switch on/does
not react.
The appliance is not
switched on.
Make sure that the appliance is properly
connected to the power supply.
Press the On/Off button
4 to switch
on the appliance.
The mains plug is not
plugged in.
Insert the plug into a mains power socket.
The socket is not
supplying any power.
Check the house mains fuse.
The appliance is
defective.
Switch off the appliance and pull out the
mains plug.
Contact Customer Service (see section
Service).
The colour of the il-
luminated ring
w
does not change.
The particle sensor is
dirty.
Clean the particle sensor (see section
Cleaning the particle sensor).
The filter change
button
3 is
flashing even
though the filter
has already been
changed.
The filter timer has not
been reset.
Press the filter change button 3 for
about 3 seconds to reset the filter timer
(see section Changing the filter).