■ 8
│
GB
│
IE
SMA 500 F1
Note: If you want to stop the preparation process before it is finished,
press the function button 9 or remove the appliance from the base 0.
You will have to reselect the programme when you resume the prepara-
tion process.
♦ Remove the container 4 from the base 0 and fill it with milk. Add at least
enough milk to reach the MIN mark
(= 70 ml) inside the container 4.
However, do no fill it with milk beyond the corresponding MAX marking,
otherwise the appliance will overflow:
– Up to the lower MAX marking
(= 150 ml), if you want to froth
milk.
– Up to the upper MAX marking
(= 300 ml), if you only want to
heat the milk (with only a little froth).
♦ Put the lid 1 on.
♦ Place the container 4 on the base 0.
Note: There is a notch on the lid 1 near the sealing ring 2. Make
sure that the notch is not directly next to the spout of the container 4.
Otherwise, milk may leak through the opening. Turn the notch to another
position on the container wall.
♦ Use the function button
9 to select the appropriate programme:
Control lamp Programme Selection
5
Heat milk with stiff froth Press 1x
6
Heat milk with creamy froth Press 2x
7
Heat milk with little froth Press 3x
8
Froth cold milk Press 4x
Once a programme is selected by pressing the function button
9,
the corresponding control lamp 5/6/7/8 lights up continuously.
♦ The control lamp 5/6/7/8 indicates the end of the programme by
flashing. The appliance switches off automatically.
If you want to stop the preparation process before it is finished,
press
the function button 9 or remove the appliance from the base 0.
You will have to reselect the programme when you resume the prepara-
tion process.
To Next Page
Loading...
