31GB/IE
Signal tone
o During use, the product emits signal tones:
Signal tone Action
Short The product is connected
to the mains.
Each time a button is
pressed.
Continuous The water level is below
the
Min
mark.
Air outlet adjustment
o Adjust the position of the air outlet’s []
ventilation flaps by hand.
Using the cooling packs
1. Put the cooling packs [] in the freezer for
24 hours at –18 °C.
2. Place the frozen cooling packs
[] into the
removable water tank
[].
Cooling conditions
o Suggested area: ≤ 11.6 m
3
o Suggested water temperature:
– Ambient temperature (air temperature
decrease: max. 1 °C in the first hour)
– +8 °C (air temperature decrease:
max.1.6 °C in the first hour)
NOTES:
o The cooler the water, the higher the cooling
efficiency.
o The cooling efficiency decreases over time, as
the water temperature gradually adapts to the
room temperature.
Timer
Displaying the set hours
One or more illuminated indicators (1h
[6],
2h
[5], 4h [4], 8h [3]) indicate the number of
hours set:
1 2 3 4 5 6 7 8 9 1011121314
15
1h
• • • • • • • •
2h
• • • • • • • •
4h
• • • • • • • •
8h
• • • • • • • •
o Example: 1h [6] and 2h [5] are lit =
programmed time corresponds to 3 hours.
Delayed switch off
The product can be programmed to switch to
standby after an operating time of 1–15 hours.
o Press [] or [] repeatedly to set the
duration after which the product switches to
standby (see “Displaying the set hours”).
Delayed start-up
In standby mode, the product can be programmed
to turn on after 1–15 hours.
o Press [] or [] repeatedly to set the
duration after which the product turns on
(see “Displaying the set hours”).
o After setting the programs: The indicators of
[], [], [] and [] are off after
a few seconds.
[] and [] keep lighting
up.
o If desired, set the programs , , and
(see “Function overview”).
o The product remains in standby mode until the
set time has elapsed.
[] and the indicators of other programs
that will be active when the product turns on
are lit.
Auto stop function
o The product switches off automatically after
24 hours of continuous operation.
Combining programs
o The programs , , and (see “Function
overview”) can be combined with each other.
Fig. B
Example:
[2], [], 4h [4] und 2h [5],
[9], 1 [] and [] are lit =
o The product will turn on or off after 6 hours.
o Humidification ( ), oscillation ( ) and
normal mode (
) with low fan speed (1) are
active.
To Next Page
Loading...
