GB
│
IE
│
11 ■
SMS 300 B2
Cleaning the HEPA dust filter
Ƈ After you have removed the HEPA dust filter 4 from the dust container 3,
place the HEPA dust filter 4 in a plastic bag. Close the plastic bag and
knock the HEPA dust filter 4 out carefully.
Ƈ Wait until the dust in the plastic bag has settled and then remove the
HEPA dust filter 4 from the plastic bag. Close the plastic bag again and
dispose of it afterwards.
Ƈ If necessary, you can rinse out the HEPA dust filter
4 with fresh cold or
lukewarm water. Allow the HEPA dust filter
4 to dry out completely.
Ƈ After cleaning, replace the HEPA dust filter
4 in the dust container 3 so
that it is firmly seated.
Ƈ Replace the empty dust container 3 with the inserted HEPA dust filter 4 in
the recess for the dust container 3 on the appliance.
NOTE
► New HEPA dust filters
4 can be reordered from the customer service
(see section Ordering spare parts).
Cleaning the UV-C lamp
WARNING! RISK OF INJURY!
► The UV-C lamp
8 gets hot during use. Allow the UV-C lamp 8 to cool
down sufficiently after use. Otherwise, there is a risk of burns.
Ƈ Use a screwdriver to loosen the screw on the cover
e of the UV-C lamp 8
and remove the cover e.
Ƈ Wipe the UV-C lamp 8 with a dry duster.
NOTE
Ƈ Be careful not to touch the UV-C lamp
8 with your fingers.
Ƈ Put on the cover
e and fix it again with the screw.
Changing the UV-C lamp
WARNING! RISK OF INJURY!
► The UV-C lamp
8 gets hot during use. Allow the UV-C lamp 8 to cool
down sufficiently after use. Otherwise, there is risk of burns.
► The technical information data for the UV-C lamp 8 can be found in the
section Technical data.
Ƈ Use a screwdriver to loosen the screw on the cover
e of the UV-C lamp 8
and remove the cover e.
Ƈ Pull the UV-C lamp 8 out of the plug connections.
Ƈ Insert a new UV-C lamp 8 into the plug connections.
Ƈ Put on the cover
e and fix it back in place with the screw.
To Next Page
Loading...
