11GB/IE/NI/MT/CY
Pairing product and mobile
device
NOTES:
Screenshots are from the iOS 13.3 app version
(if not otherwise marked). Older iOS versions
may have functional limitations.
The Android version of the app follows the
same principles as the iOS version; you might
encounter discrepancies between the two
platforms, such as slightly different on-screen
commands or icons.
Updating the firmware might result in changes
to the app’s functionality.
An updated instruction manual can be found
here:
{
Me
}
tab:
Tap
{
User Manual
}
.
Preparation
Install Lidl Home app and setup Gateway
( Gateway instruction manual).
D
[9]
1. Pull protective strip [9] out of battery
compartment [7] (fig. D).
If already mounted: Remove product from wall
bracket [].
2. Wait until flashing red LED [5] goes off after a
warm-up phase of approx. 30 s.
3. After the warm-up phase has ended, the
product switches to test mode. If the movement
of a human body is detected in test mode,
a notification will be sent to the user as a
reminder. After 20 minutes, the product
automatically switches to power saving mode.
NOTES:
If the movement of a human body is detected
in power saving mode, a notification will be
sent to the user as a reminder. If a human body
is permanently moving within the detection
area, this will not be registered as multiple
motions. If no movement has been detected
in the detection area for at least 1 minute, the
product will start again to detect movements of
a human body.
If you want to switch to test mode, remove the
battery from the battery compartment and
reinsert it.
To Next Page
Loading...
Need help?
General
