Silvercrest SPB 2.600 D1 - 7.2 Checking the charge level; 7.3 Charging external devices

SilverCrest SPB 2.600 D1
English - 33
Alternatively you can also use the USB mains
adapter of your mobile device to charge the
battery of the Power Bank, provided its output
meets the following values:
5V , at least 1 A.
7.2 Checking the charge level
You can also check the charge level of the Power Bank when
it is not being charged or discharged. To do this, briefly press
the Charge level/START button (1). The LEDs (2, 3, 4, 5) give
you information about the charge level of the Power Bank for
approximately 30 seconds.
LED display Charge level
All LEDs light up 75–100%
Three LEDs light up 50–74%
Two LEDs light up 25–49%
One LED lights up 1–24%
All LEDs off 0%
Please note that the LED display gives only an approximate
value of the actual charge level of the Power Bank.
7.3 Charging external devices
 To charge an external device with the Power Bank, connect
the Power Bank with the external device using the supplied
USB charging cable (B). To do this, plug the Micro-USB
connector of the USB charging cable (B) into the Micro-