SPB 2600 C2
■ 12
│
GB
♦ Connect the USB plug of the charger cable
to a switched-on PC or a USB power supply
(not supplied).
♦ Connect the microUSB plug of the charging cable
to the microUSB charging port on the
Power Bank. An estimate of the charge level is
shown by means of the charge level LEDs .
LED display Charge level
One LED is flashing < 20%
One LED is on, the second LED
is flashing
20–49%
Two LEDs are on, the third LED
is flashing
50–74%
Three LEDs are on, the fourth LED
is flashing
75–97%
All LEDs are on 98–100%
Checking the charge level
You can also check the charge level of the Power
bank when it is not charged or is being used for
charging.
♦ Press the ON/OFF button
briefly. The LEDs
show the current charge level of the Power bank
for about 30 seconds.
To Next Page
Loading...
